The ‘workhorse’ of the plastics industry, polypropylene is one of
COPP: Co-polymer Polypropylene
This is a specially modified highly transparent polypropylene random copolymer with medium melt flow, intended for injection moulding and injection stretch blow moulding. In addition to these properties, COPP is the best material for active hinges.
A thermoplastic material composed of polymers of ethylene. Polyethylene is the most widely produced polymer available in various densities.
HDPE: High Density Polyethylene
Its comparatively high density gives HDPE high stiffness, good temperature resistance and very good water vapour barrier properties.
LDPE: Low Density Polyethylene
Commonly used for reducer plugs in packaging or can be blended with HDPE to adjust overall density.
LLDPE: Linear Low Density Polyethylene
Typically used for tubes, LLDPE is a material that is slightly stiffer and more stable than LDPE. It is also less prone to warpage and distortion on thin
PET: Polyethylene Terephthalate
PET plastics are clear in appearance and are available in a range of colours. Although lightweight, PET is tough and a good defence to gases and liquids. It is also highly resistant to dilute acids, oils and alcohols.
PETG: Glycol - modified
PCTG: Poly - Cyclohexylenedimethylene Terephthalate Glycol
This co-polyester material is similar to PETG and can be processed in the same manner. It has better chemical resistance and is generally easier to process than PETG. It can also create larger capacity and heavier weight containers through extrusion blowmoulding processes than with PETG.
PVC: Polyvinyl Chloride
A thermoplastic material composed
BDS: Butadiene - Styrene Block Copolymer
Has the clarity of SAN, but with the addition of an impact modifier. This allows moulding to flex without fractures
SAN: Styrene - Acrylonitrile Resins
The SAN copolymer generally contains 70 to 80% styrene and 20 to 30% acrylonitrile. This combination provides higher strength, rigidity, and chemical resistance than polystyrene, but it is not quite as clear as crystal polystyrene and its appearance tends to yellow more quickly.
Protects against moisture and maintains its strength and shape even after long periods of time. Offers high clarity and rigidity.
PCR: Post Consumer Recycled material
With the increased awareness of protecting the environment and consumer awareness for the need to recycle, M&H is able to offer post consumer recycled material, which is re-used, broken down plastic bottles and containers. PCR can be offered between 25 -100% and in PET, HDPE and PP, and can be used for injection, blowmoulding and extrusion processing requirements.
PROPERTIES OF PLASTIC
HDPE = High Density Polyethylene
E = Excellent VG = Very Good G = Good F = Fair P = Poor U = Unsatisfactory M = Moderate H = High
Please note: There are many grades of each material and these are to be used as a guide only. We strongly recommend you carry out your own tests to approve material compatibility.
* The Plastics ID Code identifies the type of plastic resin from which a product is made. The Society of the Plastics Industry introduced the system in 1988 in response to demands for easier recycling of post consumer plastics. The code was therefore developed to help recyclers by providing manufacturers with a uniform system. Since 1988 a wide range of plastics has been developed which are not covered by an individual number - these plastics are identified within the “7 other” classification. M&H adopt this system as it is the only globally recognised system available.